diff --git a/README.md b/README.md
index 0d47ca5..32ab6c5 100644
--- a/README.md
+++ b/README.md
@@ -17,13 +17,10 @@ Convert any SVG 1.1 path to gcode for a pen plotter, laser engraver, etc.
 - [ ] Rustdocs
 - [ ] End-to-end tests
 
-## Known bugs & whether fixed
+## Known bugs/issues
+- [ ] Ellipse paths are dubious -- large_arc, sweep may need to be inverted
 - [ ] Smooth curves should not use the control point when the previous curve is not of the same type (quadratic -> smooth cubic, cubic -> smooth quadratic)
     - This is just a nit, it shouldn't matter if the SVG is correct
-- [x] Image coordinates mirrored in the y-axis because SVGs uses upper left corner as (0,0) while GCode uses lower left as (0,0)
-- [x] Close path command connects back to (0.0, 0.0) instead of the last move
-- [ ] Ellipse paths are dubious -- large_arc, sweep may need to be inverted
-
 
 ## Demonstration